Best answer: Why does my sewing machine keep eating my fabric?

1. It tries to eat your fabric. This most often happens when you are sewing knits and or if you start sewing too close to the edge of the fabric. … If you’re still having issues, try placing tissue paper under your fabric – it tears off easily and will help prevent your fabric from getting sucked into the machine.

How do I stop my sewing machine from eating fabric?

2) Cover the hole

Place a small piece of sticky tape over the hole in the needle plate that’s directly under the needle. I mean really small – make sure you don’t tape over the feed dogs (the little grippy tracks that feed the fabric through the machine).

What should my tension be set on on my sewing machine?

The dial settings run from 0 to 9, so 4.5 is generally the ‘default’ position for normal straight-stitch sewing. This should be suitable for most fabrics. If you are doing a zig-zag stitch, or another stitch that has width, then you may find that the bobbin thread is pulled through to the top.

IT IS INTERESTING:  Where is the bobbin winder on a sewing machine?

Why does my sewing machine keep jamming underneath?

Lack of tension on the upper thread

However certain you are that the problem with the machine is most likely due to a huge tangled mess of thread in the bobbin underneath the fabric, the most common reason for the jamming is usually the lack of sufficient tension in the upper thread.

Why does my cotton keep breaking on my sewing machine?

The upper thread tension could be set too tight. Set the tension to the best thread tension setting or less. Make sure the spool of thread is installed correctly using the correct size spool cap for the size of spool. … Check that the bobbin is wound so that it about 80% full and that the thread is evenly wound.

Why is my sewing machine eating thread?

A massive nest of tangled thread is usually a result of the sewing machine being improperly threaded. Just because the tangled mess is on the bobbin side of the stitching, don’t assume the fault lies with the bobbin. To correct this problem, put the presser foot up and unthread the sewing machine entirely.

How often should you clean and lubricate a sewing machine?

The rule of thumb is to lubricate the machine after every three to four bobbin changes. Or clean and lubricate the hook area after each day of sewing.

How do I stop my thread from bunching?

Your thread tension should be adjusted for different weights of fabric and thread. Make sure that you are using the same weight thread in both your bobbin and upper thread. If you don’t, your tension can be uneven and cause you to get bunched-up thread under your fabric.

IT IS INTERESTING:  What is the best fabric for ribbon embroidery?

What are the common sewing machine troubles?

17 Common Sewing Machine Problems and How To Solve Them

  • Thread bunching up under your fabric when sewing. …
  • Bent or broken needles. …
  • Fabric not feeding. …
  • Thread keeps breaking. …
  • Machine is skipping stitches. …
  • Bobbin tension not consistent. …
  • Seams in stretch fabrics coming out wavy. …
  • Sewing machine seizes up or won’t sew.

What tension should I use for thin fabric?

Use size 70/10 for really thin cotton like voile, size 80/12 for light to medium weight cotton, and 90/14 for thick cotton like denim.

What are the common troubles causes of troubles and remedies or solution of sewing machine?

Staggered Stitching

Cause Remedy
Incorrect or blunt needle point. Change the needle.
Incorrect needle-to-thread size relationship. Change needle or thread size as appropriate.
Feed dog sway. Tighten the feed dog.
Poor fabric control, presser foot bounce. Reset the presser foot. Change the feed mechanism.