You asked: Why is my bobbin not spinning?

If your bobbin does not wind quickly and smoothly when you press on your foot pedal, your bobbin winder might not be fully engaged. This can cause uneven winding. Make sure you push your bobbin pin all the way over or loosen your bobbin wheel completely to engage your bobbin winding mechanism.

Why is my bottom bobbin not spinning?

First, your needle may be dull or damaged and needs to be replaced. You should also check that you are using the correct needle for the type of fabric you are sewing. … If the needle is not inserted correctly, it will not be able to pull up the bobbin thread and will cause skipped stitches.

Why is my bobbin not winding?

Verify that you are using the correct size bobbins. … Align the groove in the bobbin with the spring on the bobbin winder shaft, and set the bobbin on the shaft. 3. The thread is not passed through the bobbin winding thread guide correctly.

Is the bobbin supposed to spin?

The bobbin should be turning clockwise when thread is pulled. If the thread unrolls in the wrong direction, it may cause the thread tension to be incorrect or break the needle.

Which way should bobbin go?

Insert the bobbin making sure the bobbin rotates counterclockwise when you pull the thread. NOTE: This is a very important step as the bobbin can become unthreaded and cause sewing problems if it rotates clockwise. 4. Pull the thread through the slot (A) and then to the left.

IT IS INTERESTING:  How do you know if yarn is running on spark?

Does bobbin direction matter?

Make sure the bobbin thread unrolls in the correct direction when installing the bobbin into the bobbin case. … If the thread unrolls in the wrong direction, the needle may break or the thread tension will be incorrect. Use a bobbin that has been correctly wound with thread.

Why is my thread looping underneath?

A: Looping on the underside, or back of the fabric, means the top tension is too loose compared to the bobbin tension, so the bobbin thread is pulling too much top thread underneath. By tightening the top tension, the loops will stop, but the added tension may cause breakage, especially with sensitive threads.